1
Preparing for installation
This section describes preparations for installing a CR16000-F router.
Safety recommendations
To avoid possible bodily injury and equipment damage, read all safety recommendations carefully
before installation. Note that the recommendations do not cover every possible hazardous condition.
General safety recommendations
•
Keep the chassis clean and dust-free.
•
Do not place the router on a moist area, and avoid liquid flowing into the router.
•
Make sure the ground is dry and flat and anti-slip measures are in place.
•
Keep the chassis and installation tools away from walk areas.
•
Do not wear loose clothing, jewelry (for example, necklace) or any other things that could get
caught in the chassis when you install and maintain the router.
Electricity safety
•
Clear the work area of possible electricity hazards, such as ungrounded power extension
cables, missing safety grounds, and wet floors.
•
Locate the emergency power-off switch in the room before installation so you can quickly shut
power off when an electrical accident occurs.
•
Remove all external cables, including power cords, before moving the chassis.
•
Do not work alone when the router has power.
•
Never assume that power has been disconnected from a circuit. Always check.
Moving safety
WARNING!
•
Hold the chassis handles firmly to move the router.
•
Do not hold the handle of a fan tray or power supply, air vents, or the handle on the real panel to
move the router. Doing so might cause equipment damage or even bodily injury.
The router is heavy and large. When you move the router, follow these guidelines:
•
Remove all external cables (including power cords), cards, fan trays, and power supplies before
moving the chassis.
•
Moving the chassis requires a minimum of two people, and you can use a mechanical lift as
needed.
•
Lift and put down the chassis slowly and never move suddenly.
ESD prevention
To prevent the electric component from being damaged by electrostatic discharge (ESD), follow
these guidelines:
Содержание CR16000-F
