H3C CR16000-F, Руководство по установке

Страница: 38 / 105

7
Installing a power supply
The installation procedure is the same for AC and DC power supplies. The following procedure
installs an AC power supply.
Some power supply slots do not have a filler panel. The figures in this section are for illustration only.
The CR16000-F router supports the following types of power supplies: power supplies with a captive
screw and power supplies with a power latch.
To install a power supply with a captive screw:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
For more information, see "
Attaching an ESD wrist strap ."
2. Remove the filler panel, if any, from the power supply slot.

If the filler panel has captive screws, use a Phillips screwdriver to loosen the captive screws
on the filler panel first and then remove the filler panel.

If the filler panel does not have captive screws, pull out the fill panel directly.
3. Unpack the power supply.
4. Grasping the power supply handle with one hand and supporting the power supply bottom with
the other, push the power supply along the guide rails into the slot.
5. Press the handle inward until the handle seats into the slot.
6. Use a Phillips screwdriver to fasten the captive screw on the handle to attach the power supply.
Figure 9 Installing a power supply with a captive screw (CR16010-F)
To install a power supply with a power latch:
1
2