GYS GYSPOT INVERTER BP.CX, Руководство пользователя

Страница: 9 / 29

9/29
X-clamp modes
STANDARD Mode
This mode is the default mode when the machine starts.
It allows to easily perform a welding spot by selecting :
-
The tool to be used
-
The thickness of the sheets to be welded, to choose from
0.6, 0.8, 1.0, 1.2, 1.5, 1.8, 2.0, 2.5, 3.0.
-
The type of steel to be welded (Coated steel, HTS steel,
UHTS steel, BORON steel)
-
The arm used.
Pressing the up and down key (in the circle) allows to
navigate from one parameter to the next (thickness, type
of steel, arm used). Each parameter can be adjusted by
pressing the + and – keys (in the circle).
Button C on the clamp allows to remotely change the
thickness of the sheets to be welded.
Button D on the clamp allows to remotely change the type
of steel.
Pressing button B (close / weld) allows to make a welding
spot using the selected parameters.
If the input air pressure is too low to reach the requested
electrode force, the machine will beep and display, before
the welding spot, the following error message “Pressure
too low”. Pressing again on the button allows to force the
execution of the welding spot, which will be performed with
the air pressure available.
If the welding current measured during the spot is 6% less
than the setting, the machine will display, when the spot is
completed, an error message “Current too low”, warning
that the welding spot should be checked.
In any case, a message is displayed at the end of the
welding spot showing the measured welding current and
electrode force. This message is displayed on the screen
until a key is pressed on the control panel, or until a new
welding spot is performed, by pressing the B button on the
clamp.
MULTISHEET Mode
This mode allows to precisely specify the thickness and
type of each sheet of an assembly of 2 or 3 sheets.
Using the up and down keys (in the circle) allows to select
the parameters for each sheet. When the parameters for
each sheet are highlighted, the sheet thickness and type of
steel parameters can be adjusted using the + and – keys
(in the circle).
The parameters to be adjusted in this mode are :
-
The thickness of each sheet to be welded : to choose
between the values 0.6, 0.8, 1.0, 1.2, 1.5, 1.8, 2.0, 2.5,
3.0 mm.
-
The type of steel for each sheet : coated steel, HTS
steel, UHTS steel, BORON steel.
-
In order to activate sheet 3, press the up and down keys
(in the circle) to highlight sheet 3; then use the + and –
keys (in the circle) to select the sheet thickness and type
of steel.
If the input air pressure is too low to reach the requested
electrode force, the machine will beep and display, before
the welding spot, the following error message “Pressure
too low”. Pressing again on the button allows to force the
execution of the welding spot, which will be performed with
the air pressure available.
If the welding current measured during the spot is 6% less
than the setting, the machine will display, when the spot is
completed, an error message “Current too low”, warning
that the welding spot should be checked.
In any case, a message is displayed at the end of the
welding spot showing the measured welding current and
electrode force. This message is displayed on the screen
until a key is pressed on the control panel, or until a new
welding spot is performed, by pressing the B button on the
clamp.
Pressing during 2 seconds the key allows to come
back to the “normal” mode.