GYS GYSPOT INVERTER BP.CX, Руководство пользователя

Страница: 27 / 29

27/29
Replacement of the caps/electrodes:
▪
To guarantee an efficient welding spot, it is necessary to replace the caps every 200 spots, using the dedicated caps
key.
▪
It is forbidden to grind the caps.
▪
Assemble the caps with copper grease (ref. 050440)
▪
A type caps (ref. 049987)
▪
F type caps (ref. 049970)
▪
Bevelled caps (ref. 049994)
▪
Several combinations are possible :
Level and efficiency of the cooling liquid
The level of cooling liquid is important for the good operation of the unit. It must always be between the minimum and the
maximum level indicated on the tank.
You have to check with an appropriate tool the efficiency of the cooling liquid. If this one is no more efficient, change it.
Change the cooling liquid every 2 years. Never add water. Always add cooling liquid.
Cleaning or replacement of the welding tools
Any welding tool is degraded after a certain period of use. However all tools must stay clean in order to get the best
performance of the unit. When using the unit in pneumatic clamp mode, check the good state of the CAPS electrodes (flat,
rounded or bevelled). If this is not the case, clean them with sandpaper (fine grain) or replace them (see reference on the
unit).
For a use in gun mode, it is necessary to check the state of the tools : stars, monopoint electrode, carbide electrode, … and
if they look in bad conditions clean or replace them.
The anti-dust filter at the back of the unit must regularly be cleaned to avoid the overheating of the generator.
Purging of the pneumatic filter
Regularly drain the dehumidifier filter placed on the rear side of the unit.
Generator maintenance
The maintenance and the repair of the current generator must be done by an appointed and GYS trained technician. Any
maintenance operation done by another person will cancel the warranty conditions. GYS cannot be held responsible for
damages or accidents which happen subsequently to operations performed by people exterior to GYS.