mega macs 42 SE Bike
1. Perform steps 1 to 5 as described in the section
.
CAUTION
Rolling of vehicle
Risk of injury or material damage
Proceed as follows before starting:
1. Prevent the vehicle from rolling.
2. No gear is engaged.
3. Regard the window with infos and instructions.
NOTICE
Short circuit and voltage peaks when connecting the DT VCI
Danger of destruction of automotive electronics
Switch off ignition before connecting the DT VCI to the vehicle.
2. Insert the DT VCI into the vehicle's diagnostic connector.
Both LEDs of the DT VCI flash. The DT VCI is ready for operation.
3. Select and confirm
>Codings<
.
NOTE
The selection of the following possibilities depends on the selected manufacturer and vehicle
type:
•
Functions
•
Assemblies
•
Systems
•
Data
4. Select and confirm the requested assembly.
5. Select and confirm the requested system.
6. Regard the window with infos and instructions.
7. Follow the instructions on the screen.
8. Confirm the coding done with
ENTER
.
7.3.8.2
Performing Automatic Coding Procedures
WARNING
The ECU is not coded or is incorrectly coded
Risk of death or serious injury as a result of the ECU not working or working incorrectly
Material damage of the vehicle or the ambient area
Regard the following when performing coding procedures:
•
Some working procedures require a specific training, e.g., working on the airbag.
•
Regard the window with infos and instructions.
Proceed as follows to perform an automatic coding procedure:
45
