GUTMANN FONDA 2800 ML 830, Руководство по установке

Страница: 54 / 208

EN
54
8. FITTING REQUIREMENT - Electrical connection
WARNING AGAINST ELECTRICAL
ENERGY!
THERE IS DANGER TO LIFE!
There are voltage - carrying parts near
this symbol.
Covers marked with this symbol may
only be removed by a qualified electrici-
an.
- The electrical connection may only
be carried out by an authorised spe-
cialist!
- The statutory regulations and connec-
tion conditions of the local electrical
supply company must be observed in
full.
- When the device is connected, a de-
vice must be provided which makes it
possible to disconnect the device
from the mains with an opening width
of at least 3 mm all poles using a
contact. LS switches, fuses and
contactors are regarded as suitable
disconnecting devices. When
connecting and repairing the device,
disconnect it from the power supply
using one of these devices.
- The protective conductor must be long
enough so that if the strain relief fails,
it will only be subjected to tensile
stress after the current - carrying
cores of the connecting cable.
- The excess cable length must be pul-
led out of the installation area below
the device.
- Please make sure that the mains vol-
tage is the same as on the namepla-
te.
- Complete protection against acciden-
tal contact must be ensured by instal-
lation.
- Attention: Incorrect connection can
lead to destruction of the power
electronics.
- The device is only approved for a fixed
connection. It must not be connected
with a shock - proof plug.
Connected loads
Mains voltage: 380 - 415V 2N~, 50/60Hz
Nominal component voltage: 220 - 240V
( see instructions hob )
Connecting cable available at the factory
- The hob is equipped with a tempera-
ture - resistant connection cable at the
factory.
- The mains connection is carried out
according to the connection diagram,
except the connection cable is al-
ready equipped with a plug.
- If the power cord of this unit is dama-
ged, it must be replaced with a speci-
al power cord. In order to avoid ha-
zards, this may only be done by the
manufacturer or his customer ser-
vice.