11
the hot-shoe connector and the connecting base.
Slightly press the hot-shoe connector at the front end of the camera, and push it forward until it is
completely out of the guide rail of the hot-shoe connecting base.
Note
：
Don’t forcefully install or disassemble LCD to avoid damaging the metal touch of the hot shoe.
Push LCD into the guide rail of the hot shoe, and make sure the fixed knob is locked well to avoid the bad
connect or separation of LCD.
Install or disassemble LCD in the shutdown mode.
7.
SD card In /Out
Under power-off or boot-up status is both available for the SD card operation.
Open SD card door for the operation.
Insert SD card
，
please insert metal part into it and push it inside.
Take out SD card, press down and release it. Then it would be jump out.
If there is no SD card inside camera, the information bar will display as follows:
If there is a SD card inside it
，
this icon will disappear.
Caution
：
Please do not turn off the camera when it is saving, opening and deleting images.
Please do not get out of SD card when it is saving, opening and deleting images.
Do not use this SD card for non-infrared thermal camera application.
8.
Load in/Load out Battery
Pull out lock catch to open the battery compartment.
Push one battery metal part inside it until it knocked, and then close the battery gate.
