42
So far, Wi-Fi network configuration and connection of TP9 camera is completed.
Operation methods for IR analysis software connected to TP9
Open infrared analysis software, select "File" -> "Infrared Video" -> "From device video ...", the following
dialog box will pop up:
In the above dialog box, Input TP9 Wi-Fi to obtain IP address (e.g. 192.168.1.16), and click "OK" to complete
the connection between TP9 camera and infrared analysis software.
16.
Troubleshooting
The camera does not turn on
Battery improperly installed (i.e. battery is not locked in
place). Remove battery and install correctly.
Battery contacts are dirty. Clean battery contacts.
Battery charge is low. Recharge battery or replace with fully
charged item.
Battery performance is poor
Battery may be defective. Replace battery.
Image is blurry
The target is not in focus. Adjust focus.
Brightness and contrast are inappropriate. Adjust T-min and
T-max
Visual image is blurry
The target is not in focus. Adjust focus of the visual camera.
Image contrast is low or there is no
image
Temperature set points T-min and T-max are inappropriate.
Change the lower set point and upper set point to values that
are more consistent with target temperatures.
Emissivity setting is incorrect. This affects the temperature
range set points. Check and amend the emissivity setting.
The lens cap is on. Remove lens cap.
