Gude 01841, Перевод оригинальной инструкции по эксплуатации

Страница: 17 / 56

17
The material
being cut has
traces of
burning. 1. Blunt rotary
saw.
1. Sharpen or
replace.
Maintenance table
Before
operation Check for damage of the rotary saw,
power cable, and the machine in
general.
After operation Clean the cradle saw by a brush or
use cloth to remove sawdust.
Sawdust and dust on the cooling ribs
may cause excessive heating of the
motor -> clean regularly.
As needed Sharpen the rotary saw or replace, if
needed. Make sure the teeth rake of
the rotary saw is correct.
After longer
idle period Oil the rotary saw.
Regularly Check tightening of the screw joints.
EU DECLARATION ON CONFORMITY
The company,
Güde GmbH & Co. KG
Birkichstraße 6
D-74549 Wolpertshausen
Germany,
hereby declares that the design and structure of the
devices listed below and in designs marketed conforms to
applicable basic safety and health protection requirements
of the EC.
This declaration on conformity becomes
void in case of a change to the machine not consulted
with us.
Identification of the devices:
CRADLE SAW GWS 400 ECO
Product No.:
#01841
Applicable EC directives:
2006/42 EG
2004/108 EG
Harmonized standards used
EN 1870-6/A1:2009
EN 60204-1/A1:2009
EN 55014-1/A1:2009
EN 55014-2/A2:2008
EN 61000-3-2/A2:2009
EN 61000-3-11:2000*
Date/signature of manufacturer:
16.06.2011
Information about signer: the executive
Mr. Arnold
Technical documentation:
J. Bürkle FBL; QS
* The machine complies with the requirements of the EN
61000-3-11 standard and special connection conditions
apply thereto. It means the machine can not be connected
to any power supply point. In case of adverse power grid
conditions, the voltage may temporarily oscillate. The
appliance is designed only for connection to the
connection points of which maximum permitted grid
impedance does not exceed Zmax = 0,233 . You as the
user must consult and ensure with your power provider
compliance with said requirements of the power supply
point you want to use for operation of the machine.