Guca THERMO LAVA, Инструкция по установке и эксплуатации

Страница: 16 / 20

The combustion of wastes is FORBIDDEN and it may damage the stove and the
chimney, causing health damages and spread of bad smell.
The wood is not a fuel which allows a continuous operation of the appliance, as a
consequence the heating all over the night is not possible.
ATTENTION: the continuous and protracted use of aromatic wood (eucalyptus,
myrtle etc.) quickly damages the cast iron parts of the product.
15. LIGHTING
IMPORTANT: The fi rst time that the appliance is lit, there will be an odor given off
which disappears after a short use. It must be ensured that, in any case, a good ventilation
of the environment exists. Upon the fi rst ignition we suggest loading a reduced quantity
of fuel and gradually increasing the calorifi c value of the equipment. The odors and smoke
are regular occurrences which originate from the stabilization of paint with which the
parts have been protected, that is why it is necessary that the room is ventilated.
Therefore, it is extremely relevant to take these easy steps during the lighting:
1. Make sure that a suffi cient air change is assured in the room where the appliance
is installed.
2. During the fi rst starts, do not load excessively the combustion chamber (at least
half the quantity indicated in the instructions manual) and keep the fi re continuously
ON for at least 6-10 hours with the regulators less open than the value indicated in the
instructions manual.
3. During initial ignitions do not place any objects on the stove or allow their contact
with painted surfaces.
4. After you have fi nished ‘’warming up’’, you can use your product according to the
manual, without sudden heating with the overload.
5. For lighting of fi re, we suggest using small pieces of wood with paper or other
allowed lighting means. It is FORBIDDEN to use any liquid matter, such as alcohol, gas, oil
etc.
16. REGULAR EXPLOITATION
IMPORTANT: due to the fact the door of the hearth has a remarkable size, we suggest
you to open the door very slowly, to avoid the exit of smokes and fl ames.
For safety reasons the door of the hearth can be opened during the stove operation
only for the loading of the fuel. The hearth door must always remain closed during
operation.
Before opening the hearth door, open the primary air regulator, open the door
slowly, load the fuel, close the door and after about 5 or 10 minutes close the primary air
control.
Never overload the stove (compare the technical table - max. quantity of loadable
fuel).
The warranty does not cover the damages due to overheating of the equipment.