Guca THERMO LAVA, Инструкция по установке и эксплуатации

Страница: 10 / 20

5. WOOD
Only burn dry wood! You must not only select quality wood but it must also be dry
at the moment in which you use it.
Remember that the calorifi c power of the wood drops considerably as the presence
of humidity, which means that a large part of the heat produced is used to evaporate the
water and, furthermore, the risks of obstruction increase rapidly with the condensation of
the vapors in the fl ue.
Recommended humidity of wood is up to 20%.
Damp wood not only burns badly but also makes the lighting of the fi re diffi cult and
damages the fl ue. The water vapor transports condensible products such as acetic acid,
alcohol, methyl alcohol and tars which contribute to the formation of incrustations which
are detrimental for the effi
ciency of your stove. Deposits in the fl ue may cause fi re.
Fresh cut wood is useless as a fuel. Actually a considerable part of the energy
produced is only used to evaporate the water, which is up to 75% in young wood without
bark.
ABSOLUTELY NEVER USE:
Green or damp wood, treated wood (railway sleepers, plywood off -cuts, painted
wood, etc.), low-grade anthracite and coke.
THE USE OF THE ABOVE LISTED MATERIALS AND DAMAGES CAUSED BY THEM
ANNUL ANY FORM OF GUARANTEE AND THE MANUFACTURER DECLINES ALL
RESPONSIBILITY.
6. CLEANING THE STOVE
We recommend removing the ash produced every day. Never allow the ash to
accumulate to the point where it touches the grate; this would obstruct the circulation of
primary air and slowly suff ocate the fi re.
When cleaning the outside surfaces of the stove, avoid abrasive products which
would damage the protective paint. Do not use chemicals that contain diluent, because
the cast parts are protected by heat resistant paint.
Panoramic door glass should be cleaned with normal detergent and exclusively after
getting cold. After cleaning, rinse with pure water and dry. To clean the parts in tiles use
non -abrasive detergents, water and a soft cloth which do not damage the glaze.
7. CONSUMABLES
The following are considered consumables and therefore not covered by the
warranty:
all gaskets, the parts in ceramic hardened glass, the facing of the hearth, the paints,
the ceramics and the parts with chemical coating (chrome, nickel, zinc parts). The warranty