P/N G610B
April, 2016 (Rev 0)
Page 19
0
10
20
30
40
50
60
70
80
90
100
110
120
130
Cylinder Pressure/Temperature Graph
INSPECTION AND MAINTENANCE
Monthly
, Check the discharge nozzles and heat detection
sensors for visual signs of obstruction and check the
pressure gauge. If the needle points to the "recharge" or
"overcharged" zone, contact an authorized Guardian Safety
Solutions representative immediately for service. For G600-
C Motor/Cam System see Page 16 for additional
instructions.
Annually
, a Guardian Safety Solutions, Intl. Distributor,
holding all appropriate licenses/approvals for the jurisdiction
in which the system is installed, shall test the function of and
inspect all components, including fire extinguisher unit,
appliance nozzles, sensor, distribution assembly and
shutoffs. Replace battery in the central processing unit
control board annually from the date of installation. Use only
Duracell MN1604 or Energizer EN22. Keep the Guardian
G600-B system free of cooking grease residue.
Every
Twelve (12) years,
a Guardian Safety Solutions, Intl.
Distributor, holding all appropriate licenses/approvals for the
jurisdiction in which the system is installed, shall empty and
hydrostatically test the fire extinguisher cylinder and flexible
discharge hose assembly to the appropriate test pressure
(300psi). Refill extinguisher using new wet chemical agent
by purchasing a recharge kit (P/N G-BRK) from Guardian
Safety Solution’s, Intl. (See NFPA 17A, Par. 7.5.3).
DO NOT
combine chemicals.
Solenoid Position
ENGAGED
FIGURE 28
DISENGAGED
PRESSURE(PSI)
Based upon Ideal Gas Law
FIGURE 29
Permit Number:
20-04649
