P/N G610B
April, 2016 (Rev 0)
Page 18
ACCESSORIES
(CONTINUED)
Wireless Transmitter and Receiver
Assembly (Tx/Rx)
DESCRIPTION:
The optional Wireless Receiver(Rx) (P/N G702, see
FIGURE 24
) and Wireless Transmitter(Tx) (P/N G701,
see
FIGURE 25
) are provided for situations where an
Interconnect Cable is not an acceptable means of
connecting the CPU to shut-off the cooking appliance
when the fire suppression system activates. Simply
mount the Wireless Transmitter on the side of the
System Base and plug it into the CPU (see
FIGURE 2
and 3
). The Wireless Receiver plugs into the Fuel
Shutoff in place of the Interconnect Cable and is
mounted on the wall behind the appliance (see
FIGURE 13
on page 12 and
FIGURE 17
on page 14.
Alarm / Strobe Assembly
(P/N G320-A)
DESCRIPTION:
Both electric shutoff and gas shutoff provide an
interface for a (120 volt-5A) alarm / strobe. This
assembly has a Plug & Play configuration for ease of
installation. Install in optimum location for visibility.
This feature is mainly used with the strobe function.
To perform an operational check of the alarm/strobe
assembly, perform the "Arming the System" function
as outlined in Page 15 of this manual.
See
FIGURE 10
below.
Interface Enclosure Assembly
(P/N G317-A)
DESCRIPTION:
The optional Interface Enclosure Assembly (P/N
G317-A) is provided to allow easy interfacing to
external devices or other warning /
protective
equipment. The Interface Enclosure Assembly
provides one set of dry contacts when connected with
the Gas Shutoff (P/N G316-A) and two sets of dry
contacts when connected to the Electric Shutoff.
Contact rating is 120 VAC 5 amps. Verify that
contacts switch during shut-off activation. See Page
15 for “Arming the System” procedures.
(See
FIGURE 27)
FIGURE 24
Length of
Cable
96” (8 Ft.)
FIGURE 26
FIGURE 27
FIGURE 25
18”
Permit Number:
20-04649
