P/N G610B
April, 2016 (Rev 0)
Page 16
-C
CAM
MOTOR
LATCH
For installations where the system will be subject to
vibration, there is an alternate Model G600B-C cam
activated system available.
The System is the same as the G600-B Solenoid Model
with the following exceptions:
•
The G600B-C uses a trip motor with cam for activation
instead of a solenoid. (See
Figure 19
)
•
The G600B-C cannot be installed with the optional
Wireless Rx/Tx. The Interconnect cable (P/N G622)
must be used.
•
The G600B-C System uses the G602-C Main CPU
board. This version of the Main CPU board includes a
“Motor Test/Advance” Button and includes a “TRIP
MOTOR” connection on the board instead of a
“VALVE” connection. (See
Figure 26
)
Note:
Test the Trip Motor and Cam Monthly by removing
the pull pin from the Main CPU and placing it in the handle.
Press the “Motor Test / Advance Button” and allow the cam
to make one full revolution, stopping the advancement of
the Cam just before making contact with the Latch. (See
Figure 19
) After testing, return the pull pin back into the
pull pin socket on the Main CPU board and press the
“Reset” button. The green indicator should momentarily
illuminate to indicate the system is “Armed”.
ALTERNATE CAM ACTIVATION
(SYSTEM MODEL G600B-C)
FIGURE 19
FIGURE 18
Permit Number:
20-04649
