32
1
ON
2
3
4
15
CHARGING
POWER
STATUS
RF
PULL-PUSH
MODE1
MODE2
LOCK/BEACON
OFF
120
MIN
MAX
STALL FORCE
CLOSE TIME
SET
LIMIT
LEARN
REMOTE
AUX
OUT
SOLAR
PANEL
18VAC
RCVR
GRN
BLK
RED
EXIT
SAFETY
EDGE
CY
CLE
COMMON
LINK
Wiring the Driveway Wand
Sensor to the GTO/PRO 1500
Wire from Driveway Wand Sensor
Twisted SHIELD
BLACK
RED
to
BLUE
YELLOW
Wire Nut
to EXIT
Together to
COMMON
AUX OUT (+)
The Driveway Wand Sensor is designed for residential and agricultural applications and is compatible with GTO/PRO®
automatic gate operators. The Wand Sensor is an electromagnetic sensor, which offers 'hands free' operation of the GTO/PRO®
Gate Operator with a 12 ft. radius of detection of vehicles in motion.
Driveway Wand Sensor
(FM139, FM140, FM141)
FINAL STEP
When everything has been connected to the operator...
replace the control board access cover.
If you were working with the
operator
with the control board access facing
up, remove the
operator
arm from both
mounts and remount it in the upright
position (control board cover facing
down). Failure to remount
operator
in the
upright position will allow water to enter
the operator and cause damage to the
operator control board.
Make sure the power
switch to the
operator
is turned OFF before
connecting wand
sensor wiring to the
GTO/PRO® SW-1500
terminal blocks.
The wiring cable that
comes with the GTO/PRO
Driveway Wand Sensor
has four colored wires
and a braided wire shield
around them.
Strip back a few inches
of the vinyl (black) outter
cover to expose the
braided SHIELD. Cut the
SHIELD down one side
and twist as shown in illustration. Connect the twisted SHIELD, the YELLOW, the BLACK as well as a separate
length of wire, with a WIRE NUT. The other end of the single length of wire is connected to the COMMON
terminal on the
GTO/PRO® SW-1500
control board.
Connect the RED wire from the sensor to the AUX OUT (+) terminal, and the BLUE wire from the sensor to the
EXIT (–) terminal on the
GTO/PRO® SW-1500
control board.
