31
1
ON
2
3
4
15
CHARGING
POWER
STATUS
RF
PULL-PUSH
MODE1
MODE2
LOCK/BEACON
OFF
120
MIN
MAX
STALL FORCE
CLOSE TIME
SET
LIMIT
LEARN
REMOTE
AUX
OUT
SOLAR
PANEL
18VAC
RCVR
GRN
BLK
RED
EXIT
SAFET
Y
EDGE
CY
CL
E
COMMON
LINK
Wiring Driveway Loops
to the GTO/PRO SW 1500
Wire from LOOP
V+
to AUX OUT (+)
COM
and
V–
to COMMON
NO
to EXIT
ON
1 2 3 4 5 6 7 8 9 10
DIP
NO COM NC V
+
V
–
LOOP LOOP
Wire
Nut
W
e
ather proof junction box
to house
LO
OP Controlle
r
GTO/PRO®
Free Entry/Exit Loop
A Free Entry/Exit Loop is a ground wire loop that senses a vehicle as it drives over it and opens the gate. It can be
placed in the driveway outside the gate to allow FREE Entry to the property and it can be placed in the driveway
inside the gate (beyond the path of the gate) to allow FREE Exit from the property.
Depending on how you want your gate to function you can use just one or all types on the same gate.
Make sure the power switch to the
operator
is turned OFF before
connecting loop wiring to the
GTO/PRO SW-1500
terminal blocks.
The LOOP Controller must be placed in a weather proof housing separate from the operator arm.
Use 16 gauge multi-stranded low voltage wire to connect the LOOP Controller to the GTO/PRO SW 1500 control
board.
Connect a wire from the V+ terminal on the LOOP Controller to the AUX OUT (+) terminal on the GTO/PRO
SW 1500 control board. Connect a wire from the NO (Normally Open) terminal on the LOOP controller to the
EXIT terminal on the GTO/PRO SW-1500 control board. Connect wires from the V– and COM terminals on the
LOOP controller to the COMMON terminal on the GTO/PRO SW 1500 control board. The twisted pairs of wires
from the ground loop are then connected to the LOOP terminals on the LOOP Controller. See Illustration below.
