GTO E-Z GATE, Руководство по установке

Страница: 4 / 36

ii
rev 06.13.12
Thank you for purchasing an E-Z Gate Opener "do-it-yourself” automatic gate opener! When correctly
installed and properly used, your E-Z Gate Opener will give you many years of reliable service. Please read
the following information to ensure you have the correct system for your particular needs. Furthermore, this
manual will enable you to properly install your E-Z Gate Opener.
The E-Z Gate Opener is designed for installation on Pull-To-Open dual gate leaves (gates that open into
the property). By purchasing accessory brackets [E-Z GATE Push Bracket], the E-Z Gate Opener can
accommodate Push-To-Open dual gate leaves (gates that open out from the property). Please see Pull-To-
Open/Push-To-Open diagram on page 3. The gates must not exceed 12 ft. or 300 lbs. per leaf (see Technical
Specifications on page 1). The E-Z Gate Opener can be used on vinyl, aluminum, chain link, farm tube, and
wrought iron gates.
Use on solid (surface) gates is not recommended. Solid surface gates have a high resistance
to the wind. If the wind is strong enough, the opener will obstruct and stop, blow fuses, or
may damage the equipment.
The E-Z Gate Opener features an adjustable stall force setting. This safety feature makes the gate stop and
reverse direction within 2 seconds when it comes in contact with an obstruction. The MIN setting means the
gate will exert the minimum force on an obstruction before it stops and reverses direction. You will need to
adjust the stall force for your particular application .
The E-Z Gate Opener also has an adjustable auto-close feature. After the gate reaches the fully open
position, it can be set for OFF, or to remain open from 3 to 120 seconds before automatically closing.
Pressing the remote button at any time after the gate opens fully will cause it to close immediately. The auto-
close factory setting is OFF, meaning the gate will stay open until you press the remote (or keypad, etc.) again.
The E-Z Gate Opener accommodates extra remotes, digital keypads, solar panels, and other access control
products.
PLEASE NOTE—If your application requires any of the following:
Column Mounting
Slide gates
Swing gates longer than 12 feet or weighing more than 300 pounds
Professional installation
please call GTO at 800-543-4283 or 850-575-0176 for information about our GTO/ACCESS SYSTEMS
professional line of gate openers and accessories. Our Sales Department will be glad to give you the
name and phone number of a GTO/ACCESS SYSTEMS dealer near you.
BEFORE YOU BEGIN TO INSTALL YOUR AUTOMATIC GATE OPENER:
Read these instructions carefully and completely to become familiar with all parts and installation steps.
You must read the installation manual for detailed instructions on gate opener safety and proper use of
the gate opener.
All E-Z GATE openers run off of 12 volt battery power. This installation requires the battery
charge to be maintained by either a 14 volt transformer OR an optional solar panel
connected by 16 guage, low voltage, stranded, dual conductor, direct burial wire.
NEVER USE TRANSFORMER AND SOLAR PANEL(S) AT THE SAME TIME!
It will damage the control board
PLEASE READ THIS FIRST