15
device. Oil must be checked and at
proper level for engine to start and run.
WARNING! Exhaust heat/ gases could
ignite combustible, structures or damage
fuel tank causing a fire, resulting in death,
serious injury and/or property damage.
Contact with muffler area could cause
burn resulting in serious injury. DO NOT
touch hot parts and AVOID hot exhaust
gases.Allow equipment to cool before
touching.
•
Keep at least 150cm of clearance on all
sides of generator including overhead.
• When engine starts, move choke lever
to 1/2 “CHOKE” position till engine runs
smoothly and then fully into “RUN”
position. If engine falters, choke back to
1/2 “CHOKE” position till engine running
smoothly and then fully into “RUN”
position again. If battery is unavailable,
use manual starting instructions.
• If engine is choking and running move
choke lever to the “CHOKE” position and
repeat starting instructions.
WARNING! Starter cord kickback
(rapid retraction) will pull hand and arm
toward engine faster than you can let
go which could cause broken bones,
fractures, bruises, or sprains resulting
in serious injury. When starting engine,
pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
Never start or stop engine with
electrical devices plugged in and
turned on.
• If engine fails to start after 3 pulls, or if
unit shut down during operation, make
sure unit is on a level surface and check
for proper oil level in crankcase. This
unit is equipped with a low oil protection
• Replacement parts must be the same
and installed in the same position as the
original parts
NOTE: Do not overload the generator.
Also,do not overload individual
panel receptacles. These outlets are
protected against overload with push-
to-reset-type circuit breakers.
If amperage rating of any circuit
breaker is exceeded, that breaker
opens and electrical output to that
receptacle is lost.
Connecting Electrical Loads
• Add up the total wattage of all electrical
devices to be connected at one time.
This total should NOT be greater than
the generator’s wattage capacity.
NOTE: The rated wattage of lights
can be taken from light bulbs. The
rated wattage of tools, appliances and
motors can usually be found on a data
label or decal affixed to the devices.
If the appliance, tool or motor does
not give wattage, multiply volts times
ampere rating to determine watts
• For recoil start, firmly grasp the recoil
handle and pull slowly until increased
resistance is felt. Pull rapidly up and away.
Recoil Start
Содержание GT3800Ei
Страница 1: ......
