GT POWER GT3800Ei, Руководство по эксплуатации

Страница: 10 / 24

10
Generator Ground / Earth
Circuit (7)
The Earth terminal is used to earth the gen-
erator when earthed electrical devices are
being used. Consult an electrician for local
earthing regulations.
AC (3) and DC (5) Reset
Circuit Breakers)
The Circuit Breakers turn the generator
“OFF” automatically when an electrical de-
vice connected to the generator is operating
above the rated current. To use this equip-
ment again, turn on the Circuit Breaker by
pressing in its button to “ON”. If Circuit Break-
er cuts power out again, reduce the load of
the connected electric device below the
specified rated output of the generator and
press button in to “ON” again.
3 5
NOTE:
If the Circuit Breaker continues
to cut out, stop using the device imme-
diately and consult your local author-
ised Powertec Service Provider.
according to the connected electrical load.
The results are better fuel consumption and
less noise.
When the switch is in the “OFF” position the
engine runs at 3600rpm regardless of wheth-
er there is a load connected or not.
NOTE: The ECO switch must be
turned to “OFF” when using electrical
devices that require a large starting
current, such as a compressor or a
submergible pump.
ECO Mode Switch (8)
When the ECO switch is in the “ON” position
the smart throttle controls the engine speed
8
USB Outlet (6)
The USB outlet is used to power and charge
anything with a USB plug, such as phones,
media players and other 5V DC devices.
7
6
NOTE: Remember that many types
of equipment need extra consump-
tion for start up. Equipment that uses
an engine such as compressors, wa-
ter pumps, circular saws etc. can con-
sume up to 3 times more power for
start up. For example a 1000W water
pump will need 3000W to start up,
therefore a generator 3000W or more
would be required.