GSI Group PNEG-1421, Руководство по сборке и эксплуатации

Страница: 24 / 52

24
PNEG-1421 Direct Gear Drive Bin Sweep Auger
INSTALLATION
D. Install the Flighting.
Attach a flighting section to the u-joint stub located on
the gearbox. Making sure that the Dura-Edge side of
the flight faces the center of the bin. Secure it with bolts
(see Note), and stover nuts. (See Figure 10-D)
E. Install the Connecting Stub to Sweep Flight.
1. Insert the connecting stub into the flighting.
Secure it with bolts (See NOTE), and stover
nuts.(See Figure 10-E).
F. Install the Bearing Bracket
1. Place the hanger bearing bracket onto the
connecting stub. (See Figure 10-F).
15'
1 5' 6"
18' 1 7' 0"
21' 1 8' 6"
1 4' 4"
1 5' 6"
1 5' 6"
1 5' 10"
1 5' 6"
1 7' 4"
1 5' 10"
1 8' 6"
1 7' 4"
1 8' 6"
1 8' 6"
1 8' 10"
1 4' 4"
1 7' 0"
1 7' 4"
1 7' 0"
2 7' 4"
Lengths
24'
39'
42'
48'
# of Flighting and
Shields Required
27'
30'
33'
36'
Bin Size
6" Two (2) 7/16" x 2-1/2" Bolts
8" Two (2) 1/2" x 3" Bolts
10" Two (2) 1/2" x 3" Bolts
Use the chart below to determine the number of
flighting and shield sections needed for the length
of sweep to be used.
G. Install the Sweep Flighting.
1. Install the next section of flighting onto the
connecting stub. Secure the flighting with bolts
(See NOTE) and stover nuts. (See Figure 10-G)
2. Keep repeating steps E – G for additional sections
of flighting.
Fig. 10-D
Fig. 10-E
Fig. 10-F
Fig. 10-G
Dura-Edge Flight
(See Note for
bolt size.)
Connecting
Stub
(See Not e for
bolt size.)
Stover
Lock Nut
Hanger Bearing Bracket
Connecting Stub
Sweep
Flighting
Stover Nut
(See Not e for
bolt size.)
10. Install the Sweep Flighting
(cont.)