GSI Group PNEG-1421, Руководство по сборке и эксплуатации

Страница: 32 / 52

32
PNEG-1421 Direct Gear Drive Bin Sweep Auger
OPERATION
17. FINAL CLEAN-OUT
The following procedure is recommended for cleaning the floor of the bin after the sweep auger has removed as much
grain as possible.
1. Clean (scoop and sweep by hand) the outer area of the floor into a circular pile towards the center of the bin.
(See Fig. 17-A)
2. Get out of the bin.
3. After making sure everyone is outside the bin and clear of the equipment, start the under floor unloader and the
sweep auger. In a short time, the circular pile towards the center of the bin will have been removed.
4. Stop the equipment and lock out.
5. Scoop and sweep by hand the remaining floor area to the center of the bin. (See Fig. 17-B)
6. Get out of the bin.
7. Repeat steps 3, 4, 5, and 6 until all grain has been removed from the bin.
Keep out of bin while sweep is in operation. Rapidly traveling sweep auger. The sweep
auger will move rapidly around the bin when the bin is nearly empty.
Stay clear of the under floor unloader at the bin wells. The under floor unloader is
exposed at these locations in the bin floor.
FIG. 17-A
FIG. 17-B
TOP VIEW OF BIN
SWEEP
AUGER
BIN WALL
BIN WELLS
CLEANED AREA
REMAINING GRAIN
SWEEP
AUGER
BIN WALL
BIN WELLS
DO NOT enter a grain bin unless all power driven equipment has been shut
down and locked out.