GSI Group 890-00583, Руководство пользователя

Страница: 70 / 90

Chapter 12: Troubleshooting
The disconnected line icon is
displayed Make sure the entry line is plugged in the right phone jack of the phone plug-in
card.
Make sure the plug-in card is properly inserted in the "PHONE CARD"
connector.
If the problem persists, unplug the telephone jack from the phone plug-in card
and contact you dealer.
The phone card disconnected
icon is displayed
Make sure the plug-in card is properly inserted in the "PHONE CARD"
connector.
Check the phone line wiring.
If the problem persists, unplug the phone card and contact your dealer.
The siren doesn’t work Make sure the siren load does not exceed the circuit capacity.
If no siren is connected to the siren terminals, a resistor must be connected in
its place (1.5kΩ,½ W) or you can disable the siren output .
If the siren impedance is too high, add a 1,5K Ω, ½W resistor to the siren cir-
cuit, as close to the siren as possible.
The siren wire or the siren may be defective.
If the problem persists, contact your dealer.
I plugged the battery into the
controller and it doesn’t start On first startup, the controller needs to be powered by the main sector.
The system does not detect any
probe Make sure the flat cable between the top and the bottom board inside the
enclosure is properly connected.
Make sure the removable terminal block is prop¬erly inserted on the bottom
board.
Check the wiring of the zone inputs.
If the problem persists, contact your dealer.
The system shuts down as
soon as I unplug the main
sector Make sure the battery is correctly connected.
Let the system recharge the battery for about 3 hours and a half.
Make sure the loads connected to the siren output, 12VDC output, 28 VDC
output, SBI power output do not exceed the circuit capacity.
If the problem persists, contact your dealer.
The system refuses to arm
Make sure a intrusion zone is programmed.
Make sure there is no active alarm in any intrusion zone.
Login with the installer or master password.
If the problem persists, contact your dealer.
Phone communication troubles
Problem Cause Solution
I cannot change the relay status on
the phone The relay is assigned to a zone When a relay is assigned to a zone,
it is not possible to change its status
on the phone (the relay status is
related to the zone status).
70 895–00677 Agri-Alert 128 Touch