GSI Group 890-00583, Руководство пользователя

Страница: 57 / 90

9
Configuring a Dry Contact Zone
Topics Covered in this Chapter
▪ Naming the Zone with a Text Label
▪ Selecting a Partition
▪ Selecting a Module
▪ Selecting an Input
▪ Selecting a Zone Type
▪ Setting the Alert Recognition Time
▪ Setting the Alert Recovery Time
▪ Resetting the Daily Minimum and Maximum
▪ Choosing the Type of End of Line Resistor
▪ Selecting the Type of Contact in the Dry Contact Zone
▪ Activating a device in the Event of an Alert or Trouble
▪ Receiving a Phone Call When an Alert is Active
▪ Receiving an E-mail When an Alert is Active
▪ Enabling the Siren
▪ Enabling the Internal Speaker
▪ Recording the Zone Audio Label
▪ Viewing Zone Calibration
▪ Calibrating the Zone Trouble Thresholds
Naming the Zone with a Text Label
The zone text label is a name you give to a zone to facilitate its identification. In addition to the zone
number, the text label appears everywhere where the zone is identified in writing on the user interface.
1. In edit mode, under the General tab of the zone you are configuring, click on the edit field next to the
Name button.
2. Type in the zone label of your choice.
NOTE: The field is limited to XX characters.
Selecting a Partition
Partitions are used to group zones that are located in the same area or that are logically connected
together. This can represent entire buildings or portions of a building. If you select the same partition in the
zones belonging to a specific area, monitoring is done with one partition instead of several zones. Zones in
a partition can also be bypassed and activated collectively.
What You Should Know
NOTE: In order to be available for assignment, a partition must be created.
1. In edit mode, Under the General tab, click on the edit field next to Partition.
2. Click in the circle to the left of the partition of your choice.
895–00677 Agri-Alert 128 Touch 57