GSI Group 890-00583, Руководство пользователя

Страница: 48 / 90

Chapter 8: Configuring a 0-5 Volt Zone Type
1. In edit mode, Under the General tab, click on the edit field next to Partition.
2. Click in the circle to the left of the partition of your choice.
Figure 8-1 Example of a partition
BUILDING 1
AGRI-ALERT
PARTITION 1
PARTITION 2
ZONE 1 ZONE 2
ZONE 3
ZONE 5
ZONE 4
ZONE 6
ROOM 1
ROOM 1 ROOM 2
ROOM 3 ROOM 4
ROOM 2
BUILDING 2
Selecting a Module
By selecting a module you link the zone to the area you want to monitor.
1. In edit mode, under the General tab, click on the Module edit field to display the selection box.
2. Select a module from the list.
NOTE: Only the modules that are connected to the system and that are initialized in the system are
available for selection.
Selecting an Input
1. In edit mode, under the General tab, click on the Input edit field to display the selection box.
2. Select the input from the list.
Selecting a Zone Type
Selecting a zone type allows the system to properly interpret the data received from the selected input
What You Should Know
IMPORTANT: The selected zone type must correspond to the type of sensor associated with the input you
selected.
1. In edit mode, under the General tab, click on the Type edit field to display the selection box.
2. Select a zone type from the list. Once a zone type has been selected, the configuration page displays
the appropriate settings.
NOTE: The outdoor temperature zone type is not available if it has already been assigned to a zone.
48 895–00677 Agri-Alert 128 Touch