Grundfos PC Tool CU 300, Инструкция по установке и эксплуатации

Страница: 7 / 24

7
G100 hardware
configuration If you are not using G100 you can skip to the section Getting started, page 8.
Accessing G100 via the Service Port requires no changes in the hardware configu-
ration. A communication speed of 9600 baud is the factory setting.
If you are using G100 R/M/P Port 1 to communicate with CU 300, this requires the
Port 1 DIP switches on the R/M/P expansion board to be correctly set. You need to
dismantle the front cover. The DIP switch is located at the edge of the circuit board
close to the middle. See also the G100 Installation and operating instructions.
* Factory setting
G100 R/M/P Port 1 DIP switch setting
Function
DIP switch No.
1 2 3 4 5 6 7 8
IO type
Direct * 0 0 - - - - - -
Modem 1 0 - - - - - -
Radio 0 1 - - - - - -
Protocol
Auto detect * - - 0 0 0 - - -
Speed of
communication
1200 baud - - - - - 0 0 0
2400 baud - - - - - 1 0 0
4800 baud - - - - - 0 1 0
9600 baud * - - - - - 1 1 0
19200 baud - - - - - 0 0 1