Groen HY-3E, Руководство оператора и по обслуживанию

Страница: 28 / 38

OM/SM-HY-3E & HY-5E(CE)
28
Control Transformer
Electric Heater Assembly - High Limit Thermostat
Switch Box Mounted Above
2. Note the position and identity of the
terminals and then remove them from the
control transformer.
3. With a 5/16 inch nutdriver, remove the four
10-32 screws holding the control transformer
to the service tray.
Note: Do not lose lock washers at the ground
wire.
4. Remove control transformer from the service
tray.
To Install:
5. Install the control transformer in the service
tray.
6. Fasten the control transformer to the service
tray with four 10-32 screws using a 5/16 inch
nutdriver.
Note: Ground terminal between lock
washers.
7. Reattach terminals to control transformer.
WARNING
DISCONNECT THE POWER SUPPLY BEFORE
BEGINNING ANY SERVICE PROCEDURE.
L. Gasket Heater Element
P/N 042366 P/N 123102 (240 Volt)
High Limit Thermostat
P/N 122009
1. Turn off all power to the steamer.
2. Remove the six terminals and two plugs
from the heating element.
3. With a 1/2 inch socket wrench, remove the
four nuts and lockwashers holding assembly
to generator.
4. Carefully slide the assembly about 2 inches
out of the steam generator.
5. Remove the two 6-32 self tapping sheet
metal screws from the underside of the
thermostat switch.
6. Remove the two terminal wires attached to
the thermostat Electric Heater Assembly
switch.
https://appliancetechmanuals.com