Grizzly T32006, Руководство пользователя

Страница: 17 / 32

Model T32006 (Mfd. Since 01/20) -17
-
Installing/
Removing Bits
Any drill bit you install in the chuck must
be tight enough that it will not come loose
during operation.
To install/remove bit:
1. DISCONNECT TOOL FROM POWER!
2. Open drill chuck wide enough to
release bit and accept new bit shank.
3. Insert bit as far as possible into chuck
WITHOUT allowing chuck jaws to
touch fluted portion of bit, then hand-
tighten chuck (see
Figure 8).
4. Tighten chuck firmly with chuck key
(see Figure 8).
Note: Make sure small bits are not
trapped between edges of two jaws; if
they are, re-install drill bit or it will not be
secure enough to use for drilling.
Figure 8. Drill bit installed in chuck.
Chuck
Drill Bit
Adjusting
Headstock Position
The headstock moves vertically and pivots
around the column.
2. While holding headstock, loosen head-
stock lock handle shown in Figure 9.
Figure 9. Headstock lock handle location.
Headstock
Lock Handle
3. Adjust headstock to desired position,
then tighten lock handle to secure.
Adjusting Depth Stop
The depth stop allows you to drill holes to
the same depth every time.
To adjust depth stop:
1. DISCONNECT TOOL FROM POWER!
2. Loosen set screw shown in Figure 10
before lowering bit to desired height.
3. Rotate lock ring counterclockwise until
it stops (see Figure 10), then tighten
set screw from
Step 2 to secure depth.
Figure 10. Depth stop components.
Lock Ring
To adjust headstock position:
1. DISCONNECT TOOL FROM POWER!
Chuck Key