Grizzly T1244, Руководство пользователя

Страница: 22 / 32

-20-
Model T1244 (Mfd. Since 10/17)
The fence assembly on the Model T1244 has an
infeed fence and an outfeed fence. Each fence
can be moved toward or away from bit up to 2".
The entire fence assembly can be moved forward
and backward up to 4
1
⁄
4
".
IMPORTANT: Fences should be adjusted as
close to the bit as possible without touching in
order to minimize risk of injury and produce best
results.
To adjust the fences, loosen the four fence adjust-
ment knobs (see
Figure 30) and the two knobs on
the bit guard (see
Figure 29 on Page 19). Tighten
all knobs when complete.
To adjust fence assembly forward/backward,
loosen the two fence assembly adjustment knobs
shown in
Figure 31 and slide the fence assembly
into position. Tighten the knobs when complete. If
necessary, refer to
Squaring Fence & Table on
Page 21.
Figure 30. Adjusting fence boards in/out.
+/- 2"
Fence
Adjustment
Knobs
Figure 31. Adjusting fence assembly forward/
backward.
+/- 4
1
⁄
4
"
Fence Assembly
Adjustment Knobs
Three table inserts (solid, 32 ID, and 37 ID) are
included with the Model T1244 (see
Figure 32).
Figure 32. Table inserts.
Solid
Insert
32mm
Insert
37mm
Insert
Mounting
Plate
Always install the smallest table insert into the
mounting plate that still allows the router bit to
freely rotate. This provides maximum support and
stability to the workpiece during operation, which
increases safety.
Adjusting Fences Table Inserts
Straightedge Mounting Plate
Table Surface
Set
Screw
Set
Screw
Insert
Set
Screw
Set
Screw
Figure 33. Measuring router mounting plate
alignment with extension wing table.
IMPORTANT: For table saw operations that
require removal of the router fence assembly,
always install the solid table insert to create a
smooth table surface.
After changing an insert, use a straightedge to
make sure it is flush with the router table exten-
sion wing and adjust the set screws as necessary
(see
Figure 33).