Grizzly T1244, Руководство пользователя

Страница: 16 / 32

-14-
Model T1244 (Mfd. Since 10/17)
8. If your saw fence rails cover ends of router
table extension wing T-slot, modify each rail
with a notch that exposes router table exten-
sion wing T-slot, as illustrated in
Figure 18.
Fence Rail
Extension Wing
Table T-Slot
Notch
Figure 18. Example of a fence rail modification
for table T-slot access.
9. If not already installed, attach aluminum
T-slot to router table extension wing using (3)
M6-1 x 16 flat head screws (see
Figure 19).
Figure 19. T-slot installed and router table wing
extension attached to fence rails.
T-Slot
x 3
Tape
Figure 16. Positioning the tape to shim the
router table down.
— If the outside edge of the router table tilts
up, remove the extension wing and place
strips of masking tape along the top edge
of the saw table to shim the router table
down and even with the saw table from
side to side (see
Figure 16).
Note: After re-installing router table, remove
all excess masking tape with a razor blade.
8mm
Lock
Washer
M8-1.25
Hex Nut
3
⁄
8
"
Holes
M8-1.25 x 25
Hex Bolt Front Rail
Rear
Rail
Figure 17. Example of mounting router table to
rails.
Note: If necessary, mark and drill fence
rails with
3
⁄
8
" holes to align with router table
extension wing mounting holes. Attach with
supplied Class 8.8 fasteners, or buy Grade 5
fasteners at your hardware store.
6. Remove fence and front rail tube (if installed)
to give yourself clear access to fence rails.
7. Use (6) M8-1.25 x 25 hex bolts, (6) 8mm lock
washers, and (6) M8-1.25 hex nuts to secure
router table extension wing to front and rear
fence rails, as shown in
Figure 17.
10. Install router mounting plate with pre-installed
table insert. Mounting plate should only be
installed with starting pin holes on right side,
as shown in
Figure 20.
Figure 20. Proper orientation of starting pin
holes.
Mounting
Plate (Front)
Starting
Pin
Starting Pin Holes