-12-
Model T1244 (Mfd. Since 10/17)
The Model T1244 mounts on most table saws
that have 27" deep tables. If your table saw does
not have mounting holes for the installation of
the router table, you will need to drill and tap
these holes in the saw table. Also, you may have
to modify the fence rails to allow access for the
router table T-slots, and drill the fence rails to align
with the extension wing mounting holes.
Read this entire assembly section before begin-
ning the installation procedure below to make
sure the T1244 will fit your table saw.
To assemble and install router table extension
wing:
1. DISCONNECT MACHINE FROM POWER!
2. Thread M6-1 hex nut onto each M6-1 x 54
J-hook, then thread J-hooks into bottom
of table (see
Figure 11). Tighten hex nut
against table to secure.
Note: Use J-hooks to hang table saw rip
fence when not in use.
8. Insert (2) M8-1.25 x 25 hex bolts into slots on
bottom of fence bracket, then attach 8mm flat
washer and 8-lobe knob onto each bolt, as
shown in
Figure 10. Thread loosely.
7. If necessary, attach bi-directional scale to
top of each fence half. Place start points as
shown in
Figure 9, with 15" mark at fence
ends.
Figure 9. Fence bi-directional scales attached.
Bi-Directional Scale Start Points
Infeed Fence
Outfeed Fence
Installing Extension
Wing
Figure 10. Completed fence assembly.
x 2
Figure 11. J-hook mounting hole locations.
J-Hook
Mounting
Holes
Содержание T1244
Страница 11: ...Model T1244 Mfd Since 10 17 9 5mm Hardware Recognition Chart ...
Страница 32: ......