Model T1244 (Mfd. Since 10/17)
-11-
Assembling Fence
2. Slide lower T-slot on each fence half over
hex bolts installed in
Step 1, as shown in
Figure 5.
3. Slide one T-bolt into each upper T-slot on
infeed and outfeed fences (see
Figure 6).
5. Tighten (4) 8-lobe knobs from Step 1 to
secure fence to bracket.
6. Attach dust port to fence bracket using (2)
M5-.8 x 55 Phillips head screws, as shown in
Figure 8.
4. Slide router bit guard over T-bolts. Secure
with (2) 6mm fender washers and (2) 3-lobe
knobs (see
Figure 7).
1. Insert (4) M8-1.25 x 25 hex bolts into two
outer holes on each end of fence bracket,
then attach 8mm flat washer and 8-lobe knob
onto each bolt, as shown in
Figure 4. Thread
loosely.
Figure 6. T-bolts for attaching router guard
installed.
Outfeed
Fence
Infeed
Fence
Upper T-Slots
T-Bolts
Figure 5. Sliding fence half onto fence bracket
hex bolts.
Fence Bracket
Hex Bolts
Lower
T-Slot
Back of Fence
Figure 7. Router bit guard attached.
x 2
Router
Bit
Guard
Figure 8. Attaching dust port.
x 2
Fence Bracket
Dust
Port
To assemble fence:
The Model T1244 mounts on most table saws that
have 27" deep tables. Assemble the fence first,
then determine which side of the saw table you
will use to mount the router table extension wing.
The fence assembly is fully reversible.
Figure 4. Hex bolts, flat washers, and knobs
attached to left side of fence bracket.
Fence
Bracket
x 4
Содержание T1244
Страница 11: ...Model T1244 Mfd Since 10 17 9 5mm Hardware Recognition Chart ...
Страница 32: ......