Grizzly G1023S, Инструкция по эксплуатации, Страница: 17 / 52

G1023S/G1023S110 Heavy-Duty 10'' Table Saw -15-
SECTION 4: ASSEMBLY
Most of your Model G1023 Series has been
assembled at the factory, but some parts must
be assembled or installed after delivery. We
have organized the assembly process into steps.
Please follow along in the order presented here.
TOOLS REQUIRED: You will need a high qual-
ity square, a long straightedge, 10mm, 12mm,
14mm open end wrenches and a 3mm Allen
®
wrench.
Extension Wings
Inspect the extension wings for burrs or foreign
material that may inhibit assembly. The mating
edges of the wings and the table must be clean,
smooth, and flat. Use a wire brush or file if neces-
sary to clean up the edges.
1. Attach the left wing to the table using the
three hex head bolts and the flat washers
provided. Adjust the wing reasonably flush
with the table. Do not tighten the bolts.
2. Attach the right wing to the table using the
three hex head bolts and the flat washers
provided. Adjust the wing reasonably flush
with the table. Do not tighten the bolts.
3. Align the top of the wing flush with the table
top directly above the front bolt, and tighten
the front bolt. The front edge of the extension
wing should also be flush with the front edge
of the table.
4. Raise or lower the rear of the extension wing
until the middle of the wing is flush with the
table top. Tighten the middle bolt.
5. Raise or lower the rear of the wing until the
wing and table are flush. Tighten the bolt.
Any adjustment at this point should be mini-
mal.
6. Check flushness over the front bolt and re-
adjust if necessary.
7. Repeat Steps 3-4 for the other extension
wing.
The table and the wings
represent a very heavy
load. DO NOT over-exert
yourself while lifting or
moving the table and the
wings – get assistance.
Keep clothing rolled
up and out of the way
of machinery and keep
hair pulled back.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Disconnect power to the
machine when perform-
ing any maintenance or
assembly. Failure to do
this may result in serious
personal injury.
Some metal parts may
have sharp edges on them
after they are formed.
Please examine the edges
of all metal parts before
handling them. Failure
to do so could result in
injury.