Model G0825 (Mfd. Since 02/17)
-29-
SECTION 6: MAINTENANCE
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check
•
Lubricate feed & glue spindle chain.
•
Remove excess glue residue.
•
Worn or damaged wires.
•
Any other unsafe condition.
Schedule
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Cleaning &
Protecting
Lubrication
Feed & Glue Spindle Chain
Oil Type ......Grizzly SB1365/ISO 68 Machine Oil
Oil Amount ..........................................As needed
Oil Frequency .............................................. Daily
Tool Needed
Qty
Hex Wrench 3mm .............................................. 1
The feed and glue spindle chain should be
lubricated often to ensure proper operation (see
Figure 38).
To lubricate chain, DISCONNECT MACHINE
FROM POWER, and remove top cover of edge-
bander. Apply a light coat of ISO 68 machine oil
to the chain.
Turn master power switch
ON, and press heating
unit ON/OFF button to heat glue pot. Once pre-
heated, press ON/OFF button on control handle
to start feed motor and disperse oil.
Run machine for several seconds, ensuring oil
covers chain and sprockets, then turn machine
OFF. Re-install top cover.
Figure 38. Feed chain lubrication locations.
Cleaning the Model G0825 is relatively easy.
Excess glue may become lodged around feed
rollers or on outfeed base. To remove excess
glue from feed rollers, heat the unit to a working
temperature, and use an old brush, toothbrush,
plastic scraper, or wooden spoon to remove the
majority of glue residue.
For residue farther from the heater element, use a
heat gun to warm the adhesive, and gently scrape
material from the surface with a wooden spoon,
or plastic scraper. DO NOT use excessive force
to remove built-up residue, as this can mar the
work surface.
Apply light coats of silicone spray or oil on work
surfaces to keep dry and protected.
Содержание G0825
Страница 44: ......
