Grizzly G0810, Руководство пользователя

Страница: 42 / 60

-40-
Model G0810 (Mfd. Since 10/15)
Power Feed Gears
Figure 63. Location of gear guard.
Gear
Guard
Grease Type ...... T26419, NLGI #2, or Equivalent
Grease Amount ........Two Pumps of Grease Gun
Check/Add Frequency .......160 Hrs. of Operation
Materials Needed Qty
Double-Sided Adhesive Tape ............ As Needed
Rubbing Alcohol and Shop Rags ...... As Needed
To lubricate X-axis power feed gears:
1. DISCONNECT MACHINE FROM POWER!
2. Remove gear guard (see Figure 63).
Figure 64. Lubrication points for X-axis power
feed gears (as shown from below).
X-Axis
Table Gear
Power Feed
Gear
3. Brush a light coat of grease on teeth of
power feed gear and X-axis table gear (see
Figure 64).
4. Use rubbing alcohol or other appropriate sol-
vent/cleaner to thoroughly clean grease/resi-
due from mating surfaces of gear guard, then
re-install guard using double-sided adhesive
tape.
Tensioning Return
Spring
If the return spring should
come loose from the spring
cap and rapidly unwind,
laceration or impact inju-
ries could occur. Always
wear heavy leather gloves
and safety glasses when
adjusting the return spring
tension.
The spring tension for automatic quill recoil has
been pre-set at the factory. It should not need
adjustment under most normal circumstances. If
it does need adjustment, the spring housing is
located on the left side of the headstock.
Tools Needed Qty
Hex Wrench 5mm .............................................. 1
To adjust spring tension:
1. DISCONNECT MACHINE FROM POWER!
2. PUT ON SAFETY GLASSES!
3. Loosen cap screw shown in Figure 65
2–3 turns (DO NOT completely remove it).
Figure 65. Spring tension components.
Spring Cover
Cap Screw