Grizzly G0810, Руководство пользователя

Страница: 20 / 60

-18-
Model G0810 (Mfd. Since 10/15)
Assembly
Assembly of Model G0810 consists of remov-
ing the wooden shipping braces, installing the
revolving handles on the Z-Axis crank handle and
handwheels, and installing the table handwheels,
and X-axis power feed unit.
To assemble machine:
1. Thread one revolving handle into Z-axis crank
handle, then tighten jam nut (see Figure 10).
2. Loosen Z-axis table lock (see Figure 10).
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather all
listed items. To make sure the assembly process
goes smoothly, first clean all parts that have any
heavy-duty rust preventative applied by the fac-
tory (if applicable).
3. Use Z-axis crank handle to just slightly lower
table.
Note: Only exert mild pressure when lower-
ing table during
Step 3, otherwise you could
damage knee by forcing it down against
lower brace (see
Figure 11).
Figure 10. Location of Z-axis crank handle and
table lock.
Z-Axis
Table Lock
Jam Nut
Z-Axis Crank
Handle
Revolving
Handle
4. Remove upper brace, raise table slightly,
then remove lower brace (see
Figure 11).
5. Install lever shafts and handles onto coarse
downfeed hub (see
Figure 12).
Figure 11. Wooden shipping braces to be
removed during assembly.
Upper
Brace
Lower
Brace
Knee
Figure 12. Coarse downfeed levers installed.
Lever Shaft
(1 of 3)
Lever Handle
(1 of 3)
Hub