Grizzly G0796, Руководство пользователя

Страница: 35 / 96

Model G0796/G0797 (Mfd. Since 1/18)
-33-
1. DISCONNECT MACHINE FROM POWER!
2. Loosen four lock bolts shown in Figure 29.
3. Use one hand to apply pressure to head in
direction of rotation, then slowly turn rotation
bolt shown in
Figure 29.
Note: Turn rotation bolt clockwise to rotate
head left and counterclockwise to rotate it
right.
4. Re-tighten lock bolts.
Always lock head firmly in place after tilt-
ing or rotating it. Unexpected movement of
head during operations could cause dam-
age to cutter or workpiece.
Figure 29. Head rotation controls.
Rotation Bolt
Lock Bolts
Rotating Head Left/Right
Positioning Ram
The ram rotates 360° around the turret, and
travels forward or backward 12" (G0796), or 18
1
⁄
2
"
(G0797).
Tool Needed Qty
Wrench 19mm ................................................... 1
1. DISCONNECT MACHINE FROM POWER!
2. Loosen four lock bolts on top of turret (see
Figure 30).
Note: There are two lock bolts on each side
of the ram.
Note: In the next step, take care not to entan-
gle or stretch electrical cabling as you move
ram around turret.
3. Push head to manually rotate ram. Use rota-
tion scale to determine correct position for
your operation, then re-tighten four lock bolts
to secure ram in place.
Figure 30. Ram rotational controls.
Lock Bolts
(2 of 4)
Rotation
Scale
Rotating Ram
Note: The lock bolts shown in Figure 29 are
threaded into T-nuts that travel in a circu-
lar slot during head rotation. When rotating
head, it is possible for these T-nuts to jam in
the slot preventing movement of head. If this
happens, gently rotate each lock bolt, start-
ing with the lower right, until you free up the
jammed T-nut. Then continue to rotate head
to desired position.