Grizzly G0796, Руководство пользователя

Страница: 50 / 96

-48-
Model G0796/G0797 (Mfd. Since 1/18)
Table Ways (One-Shot Oiler)
Oil Type ..... Model SB1365 or ISO 68 Equivalent
Oil Amount .................. One Pull of Pump Handle
Check/Add Frequency ...... 4–8 Hrs. of Operation
The one-shot oiler is connected to a series of
aluminum tubes that carry the lubricant to wear
points along the table horizontal and vertical ways.
Pull the handle out slowly then release it to send
the oil through the tubes (see
Figure 66), then
move the table through all paths of movement to
evenly distribute the lubricant.
Use the sight glass on the side of the oiler to know
when to re-fill the reservoir. The reservoir capacity
is
1
⁄
2
liter.
Figure 66. One-shot oiler components.
Reservoir Cap
Sight Glass
Pump
Handle
Headstock Gearing (G0797)
Grease Type .....................NLGI #2 or Equivalent
Grease Amount ........Two Pumps of Grease Gun
Check/Add Frequency .........40 Hrs. of Operation
Add two pumps from a grease gun to the grease
fitting shown in
Figure 67.
Figure 67. Model G0797 headstock gearing
grease fitting.
Ram Ways
Oil Type ..... Model SB1365 or ISO 68 Equivalent
Oil Amount ............................................Thin Coat
Check/Add Frequency .........40 Hrs. of Operation
Move the ram back and forth as necessary to
access the full length of the ways (see
Figure 68),
then use a clean shop rag to apply a thin coat of
lubricant to the ways.
Figure 68. Ram ways.
Ram Ways
Head Tilt & Ram Pinions
The interaction between the cast iron surfaces
of these devices (see
Figure 69) produces a dry
powder that provides an adequate lubrication.
Do not apply any other lubricant because it could
produce a stiff compound, which may interfere
with smooth movement.
Figure 69. Head tilt and ram pinions.
Ram
Pinion Gear
Head Tilt
Rack & Pinion Gear