Grizzly G0490W, Руководство пользователя

Страница: 25 / 64

Model G0490W/G0490XW (Mfd. Since 5/16)
-23-
Belt guard MUST be installed before oper-
ating jointer or else moving belt will be
exposed, creating an entanglement hazard
at back of jointer.
18. Install belt guard with (2) M6-1 x 12 flange
bolts, as shown in
Figure 31.
Figure 31. Belt guard installed.
Belt
Guard
x 2
19. Re-install cabinet rear access panel.
20. Move fence all the way back to make room
for cutterhead guard.
21. Insert cutterhead guard shaft into jointer,
as shown in Figure 32, so shaft flat is fac-
ing set screw, then tighten pre-installed set
screw against shaft. Position the bottom of
the guard so it is no more than
3
⁄
8
" above the
table, to ensure safety during operations.
Figure 32. Tightening set screw to secure
cutterhead guard.
22. Test operation of guard by pulling it back and
letting go. Guard should spring back over
cutterhead and stop against the fence.
— If guard drags across table, loosen set
screw, raise guard slightly so that it does
not drag, then retighten set screw.
— If guard does not spring back over
cutterhead, re-install it and make sure flat
part of guard shaft faces set screw.
23. Install rabbeting table with (2) pre-installed
M8-1.25 x 20 cap screws and (2) 8mm lock
washers (see
Figure 21).
Figure 34. Knife-setting jig assembled.
24. Model G0490W Only: Assemble knife-set-
ting jig, as shown in
Figure 34.
Figure 33. Rabbeting table installed.
x 2
Rabbeting
Table