Grizzly G0490W, Руководство пользователя

Страница: 21 / 64

Model G0490W/G0490XW (Mfd. Since 5/16)
-19-
Assembly
Figure 13. Pedal assembly attached to right side
of stand.
x 3
Assembly consists of installing the pedal and
jointer assemblies, control panel pedestal, fence,
belt, safety guards, and rabbeting table. Complete
all steps in the assembly procedure prior to per-
forming the
Test Run on Page 24.
Before beginning, refer to
Needed for Setup sec-
tion and gather all applicable items.
To assemble jointer:
1. Attach pedal assembly to right side of stand
with (3) M8-1.25 x 50 cap screws, (6) 8mm
flat washers, (3) 8mm lock washers, and (3)
M8-1.25 hex nuts, as shown in
Figure 13.
Figure 15. Attaching dust port to stand.
x 4
5. From underneath shipping crate, remove two
hex nuts and flat washers securing jointer
assembly to crate.
3. With help from another person, position stand
upright.
4. Attach dust port to stand with (4) M5-.8 x 10
Phillips head screws and (4) 5mm flat wash-
ers, as shown in
Figure 15.
2. Feed power cord outside of stand, as shown
in
Figure 14.
Figure 14. Inserting power cord through stand.
Lifting Straps
Figure 16. Using lifting straps to lift jointer
assembly.
6. Wrap lifting straps around infeed and outfeed
table, as illustrated in Figure 16, then attach
ends to forklift forks or hoist.
7. With another person to steady the load, care-
fully lift jointer assembly onto stand and posi-
tion all four mounting holes into alignment
with stand mounting holes.
Note: Make sure cutterhead pulley is facing
to rear of stand.