Grizzly G0490W, Руководство пользователя

Страница: 27 / 64

Model G0490W/G0490XW (Mfd. Since 5/16)
-25-
For your convenience, the adjustments listed
below have been performed at the factory and no
further setup is required to operate your machine.
However, because of the many variables involved
with shipping, we recommend that you at least
verify the following adjustments to ensure the best
possible results from your new machine.
Factory adjustments that should be verified:
• Model G0490W Knife Settings (refer to Page
38).
• Table Parallelism (refer to
Page 42).
•
Depth Scale Calibration (refer to
Page 47).
•
Fence Stop Accuracy (refer to
Page 48).
Recommended
Adjustments
5. Push START button to start machine. A cor-
rectly operating machine runs smoothly with
little or no vibration or rubbing noises.
6. Press STOP button to turn machine OFF.
7. WITHOUT resetting STOP button, press
START button. Machine should not start.
— If machine does not start, the STOP but-
ton safety feature is working correctly.
Congratulations! The Test Run is com-
plete.
— If machine does start (with STOP button
pushed in), immediately disconnect power
to machine. The STOP button safety fea-
ture is not working correctly. This safety
feature must work properly before pro-
ceeding with regular operations. Call Tech
Support for help.
Figure 37. Resetting the switch.
4. Twist STOP button clockwise until it pops
out (see Figure 37). This resets switch so
machine will start.
Tighten Belt
The final step in the setup process must be done
after approximately 16 hours of operation. During
this first 16 hours, the belt will stretch and seat
into the pulley grooves. After this time, you must
re-tension the belt to avoid slippage and burn out.
Refer to
Page 49 when you are ready to perform
this important adjustment.
Note: Pulleys and belt can get hot. This is a nor-
mal condition. Allow them to cool before making
adjustments.
A small amount of black belt dust at the bottom
of the belt housing is normal during the life of the
machine and does not indicate a problem with the
machine or belt.