Grizzly G0490W, Руководство пользователя

Страница: 22 / 64

-20-
Model G0490W/G0490XW (Mfd. Since 5/16)
8. Attach jointer assembly to stand with (8)
M8-1.25 x 20 cap screws, (8) 8mm lock
washers, and (8) 8mm flat washers, as
shown in
Figure 17.
Figure 18. Attaching control panel pedestal to
back of infeed table.
x 2
9. Attach control panel pedestal to back of
infeed table with (2) pre-installed M10-1.5 x
20 cap screws and (2) 10mm flat washers
(see
Figure 18).
Figure 17. Jointer assembly attached to stand.
x 8
10. Verify alignment of cutterhead and motor pul-
leys, as illustrated in
Figure 19.
Cutterhead
Pulley
Motor
Pulley
Alignment
Figure 19. Example of pulleys aligned.
— If pulleys are not aligned, loosen four
motor mounting bolts shown in Figure 20,
shift motor horizontally to align pulleys,
then retighten bolts.
Figure 20. Location of motor mount bolts.
Motor
Mount
Bolts
11. Use (2) pre-installed M10-1.5 x 30 cap
screws, (2) 10mm lock washers, and (2)
10mm flat washers to attach fence carriage
base with fence onto rear of jointer assembly,
as shown in
Figure 21, and Install fence lock
lever.
Figure 21. Fence assembly and carriage
installed.
Fence
x 2
Fence
Carriage
Base
Fence Lock Lever