Grizzly G0490W, Руководство пользователя

Страница: 48 / 64

-46-
Model G0490W/G0490XW (Mfd. Since 5/16)
Setting Outfeed
Table Height
The outfeed table height must be even with the
top of the cutterhead knives. If the outfeed table is
set too low, there will be snipe. If the outfeed table
is set too high, the workpiece will hit the edge of
the outfeed table during operation, increasing the
chance of kickback.
Tools Needed Qty
Straightedge ...................................................... 1
Open-End Wrench 16mm .................................. 1
To set outfeed table height:
1. DISCONNECT MACHINE FROM POWER!
2. Remove cutterhead guard, fence, and cabi-
net rear access panel.
3. Knife-Style Cutterhead Only: Correctly set
knife heights (refer to Setting/Replacing
Knives (G0490W) on Page 38 for detailed
instructions).
4. Loosen outfeed table lock located at front of
machine, and loosen jam nuts and positive
stop bolts located at back of machine just
behind outfeed table (see
Figure 77).
6. Use motor pulley to rotate cutterhead until
one of the knives or inserts is at top dead
center (its highest point during rotation), as
illustrated in
Figures 78–79.
Figure 79. Using straightedge to check outfeed
table height.
Straightedge
Outfeed Infeed
Straightedge
Outfeed Infeed
G0490W
G0490XW
Figure 78. Knife or insert at top dead center.
Top Dead
Center
Bottom Dead
Center
Top Dead
Center
G0490W
G0490XW
7. Use outfeed table adjustment lever to set
outfeed table so that knife or insert bare-
ly touches straightedge, as illustrated in
Figure 79.
8. Tighten outfeed table lock located at front of
machine, and tighten outfeed positive stop
bolts and jam nuts located at back of machine
(see
Figure 77) so that outfeed table will not
move during operation.
9. Re-install cutterhead guard, fence, and cabi-
net rear access panel.
Figure 77. Outfeed table positive stop bolts.
Stop Bolts
5. Place straightedge on outfeed table so it
extends over cutterhead.
Jam Nuts