6
STEP 4
–
Regeneration Time (Hour): Set the hour of day for regeneration using the
s
or
t
buttons.
AM/PM toggles after 12:00. The default time is 2:00 a.m.
Press
next
to go to step 5.
STEP 5
– Next
Regeneration Time (Minutes): Set the minutes of day for regeneration using the
s
or
t
buttons. Press
next
to exit Installer Displays/Settings.
1.
General Operation:
When the system is operating one of two displays will be shown. Pressing
Next
will alternate between the displays. One of the displays is always the current time of day. The
second display is one of the following: days remaining or gallons remaining. Days remaining are the
number of days left before the system goes through a regeneration cycle. Capacity remaining is the
number of gallons that will be treated before the system goes through a regeneration cycle. The user
can scroll between the displays as desired. If the system has called for a regeneration that will occur
at the preset time of regeneration, the words
regeN
toDay
will appear on the display. When water is
being treated (i.e. water is flowing through the system) the word
softeNiNg
flashes on the display if a
water meter is installed.
4
5
o
PeraTing
d
isPlays
for
The
s
ofTener
:
2. Programming cont’d:
3.
Manual Regeneration:
Sometimes there is a need to regenerate the system sooner than when the
system calls for it, usually referred to as manual regeneration. There may be a period of heavy water
usage because of guests or a heavy laundry day.
To initiate a manual regeneration immediately, press and hold the
regeN
button for three seconds. The
system will begin to regenerate immediately. The control valve may be stepped through the various
regeneration cycles by pressing the
regeN
button.
2.
Regeneration Mode:
Typically a system is set to regenerate at a time of
no water use. If there is a demand for water when the system is regenerating,
untreated water will be delivered. When the system begins to regenerate,
the display will change to include information about the step of the
regeneration process and the time remaining for that step to be completed.
The system runs through the steps automatically and will reset itself to provide
treated water when the regeneration has been completed.
To initiate a manual regeneration at the preset delayed regeneration time, when the regeneration time
option is set to
Normal
or
Normal
+
oN
0, press and release
regeN
. The words
regeN
toDay
will flash on the
display to indicate that the system will regenerate at the preset delayed regeneration time. If you pressed the
regeN
button in error, pressing the button again will cancel the request.
