5
Time of day should only need to be set after extended power outages or when daylight saving time begins
or ends. If an extended power outage occurs, the time of day will flash on and off indicating that the time
should be reset.
STEP 1
– Press SET CLOCK.
STEP 2
– Current Time (hour): Set the hour of the day using the
s
or
t
buttons. AM/PM toggles
after 12:00. Press
next
to go to step 3.
STEP 3
– Current Time (minutes): Set the minutes of the day using the
s
or
t
buttons.
Press
next
to exit Set Clock.
1. Set time of
day:
Installer Displays/Settings
STEP 1
– Press
next
and
s
simultaneously for 3 seconds.
STEP 2
– Hardness: Set the amount of hardness in grains of hardness as calcium carbonate per
gallon using the
s
or
t
buttons. The default is 20 with value ranges from 1 to 150 in 1
grain increments.
Note:
The grains per gallon can be increased if soluble iron needs to be reduced.
Press
next
to go to step 3.
STEP 3
– Day Override: When gallon capacity is set to off, sets the number of days between
regenerations. When gallon capacity is set to AUTO or to a number, sets the maximum
number of days between regenerations. If value is set to
off
regeneration initiation is based
solely on gallons used. If value is set as a number (allowable range from 1 to 28) a
regeneration initiation will be called for on that day even if sufficient number of gallons
were not used to call for regeneration. Set Day Override using
s
or
t
buttons:
Press
next
to go to step 4.
2. Programming:
1
2
3
1
2
3
P
rogramming
P
roCedures
for
W
aTer
s
ofTeners
:
