EVO205D SAFE / SURE-Trak 5. OPERATION
5-4
©GreenMech
Ltd
5-4
03/22
5.5 Moving Machine (Fig 5.5)
Set Chip / Track switch to Track.
Push both motion levers together to start forward
movement.
Adjust Fast button (5) on controller or press and
hold toggle switch to increase speed.
Push left or right motion lever to steer.
Extend or retract legs as required at switches
shown.
At work site ensure body is level.
Press button (1) or toggle slow engine to Idle.
Note
: Drive with track motors at rear when
possible.
SureTrak Pitch Control Fig (5.5)
Pitch angle may be set up to 15deg forward or
backward to aid traversing slopes of up to
maximum 35deg. Press pitch toggle switch forward or backward to adjust.
Tracks also pivot separately to traverse bumps (e.g. stump) to reduce sidewards roll.
Cautions for tracking
CAUTION! Take care of balance when standing on platform.
CAUTION! Do not leave machine parked directly up or down slope.
CAUTION! When extending legs, do not force track against solid objects. This may
dislodge track.
CAUTION! Avoid static turns on hard surfaces. This will rapidly wear tracks
CAUTION! Point discharge chute away from driver. Over long journeys, engage
chipper drive to blow out build up of exhaust gas.
CAUTION! Do not drive directly up slopes exceeding 35 degrees.
5.6 Preparing For Transport On Completion Of Work (Fig 5.6.1)
Check that engine has stopped and chipper flywheel
is stationary.
Remove surplus material from infeed chute and all
machine surfaces.
Fold infeed chute into transport position.
Unlock, lift and secure covers to remove debris.
Replace and secure covers.
Raise rear stand and lock securely.
If detached, re-attach trailer to vehicle, raise jockey
wheel, connect safety cable and electric services.
See Section 4.4 for optional folding discharge chute.
Fig 5.6.1 Transport position
Infeed chute
Fig 5.5 Track motion controls
Motion
levers
Chip / track
Leg
switches
Idle / Run
Pitch switch
