EVO205D SAFE / SURE-Trak 5. OPERATION
5-1
©GreenMech
Ltd
5-1
03/22
5.1 Pre-Work Checks:
Check machine is stationary, Key in OFF position or removed, and hand brake applied if separated
from vehicle.
Check that machine is level and infeed chute is not less than 600mm from ground (fig 3.4.3).
Check engine oil level (See Engine instruction manual).
Check hydraulic oil level (See
Section 6).
Check fasteners for tightness and hydraulic connections for leaks.
Check condition of blades as follows:
Disengage flywheel clutch (See 5.9)
1) Raise engine cover. Check nothing is rotating.
2) Remove bolts (2) retaining chipper flywheel cover.
3) Using discharge chute handle as a lever, swing back
cover onto stop to expose chipper flywheel and blades. (fig
5.1.1)
CAUTION!
Beware sharp edges of blades and
unexpected movement.
4) Turn flywheel to align locking pin with a mating boss (2)
and release pin into boss to prevent flywheel from turning.
5) Remove any loose wood material.
6) Retract locking pin and carefully rotate chipper flywheel
to check tightness of blade bolts and condition of blades (fig
5.1.2).
7) If any bolts are loose, refer to Maintenance Section 6.7 for further action.
8) Retract and turn locking pin to prevent it springing back and replace chipper flywheel cover.
9) Tighten all bolts securely.
10) Remove any loose material and
dust from radiator and engine bay
11) Replace all covers and secure.
Check discharge chute is in desired
position pointing away from infeed
and all clamps are tight. (see
Section 4.4)
Check work area and erect signs and
cone off discharge area if necessary.
Check
ALL
safety procedures have
been followed.
CAUTION! Always work with chipper level, preferably with the infeed direction slightly down
the slope to minimise the risk of material falling back out.
Fig 5.1.2. Flywheel and blades
Fig 5.1.1 Chipper flywheel cover
Locking Pin
Cover locating
bolts (removed)
