OPERATION
31
500ze YM180 (12
−
2011)
WHILE OPERATING THE MACHINE
Perform the Pre
−
Operation Procedures before
each use (see MACHINE MAINTENANCE section
of this manual).
When sweeping, avoid bulky debris such as
crates, boxes, tree branches, and heavy material.
Avoid straps, twine, rope, etc., that could become
entangled in the brushes.
Plan the sweeping in advance. Try to arrange long
runs with minimum stopping and starting. Sweep
as straight a path as possible. Overlap the brush
paths. Use dust suppression in dusty conditions.
Avoid turning the steering wheel too sharply when
the machine is in motion. The machine is very
responsive to the movement of the steering
wheel. Avoid sudden turns, except in
emergencies.
If poor sweeping performance is observed, stop
cleaning and refer to MACHINE
TROUBLESHOOTING section of this manual.
Drive the machine slowly on inclines. Use the
brake pedal to control machine speed when
descending inclines.
Never maneuver over curbs with the brushes and
nozzle down. Always raise the brushes and nozzle
prior to moving over curbs. Never drive over curbs
at a high speed or at a 90
_
angle. Approach curbs
at approximately a 45
_
angle.
In rare circumstances one rear wheel may lose
contact with the ground when moving over curbs.
In such circumstances the rear wheel that is still
on the ground will provide the traction necessary
for the machine to continue moving over the curb.
FOR SAFETY: When using machine, go slowly
on inclines and slippery surfaces.
Maximum rated climb and descent for a full
hopper is 20%.
Fully charge both battery packs when finished
using the machine. Both battery packs must be
fully charged before the machine is again
operated. Do not allow the battery packs to be
discharged below 15%.
ATTENTION!: Battery packs damaged as a
result of being discharged below 15% will not
be covered under warranty.
SWEEPING
FOR SAFETY: Do not operate machine, unless
operator manual is read and understood.
1. Turn on the machine.
2. Place the Transit / Work mode switch into
Work Mode 1 (middle position) for sweeping.
3. Turn the Water switch to the appropriate
mode for sweeping conditions.
4. Adjust the Brush speed knob for sweeping
conditions.
