GREE ELECTRIC DC Inverter U-match Series, Руководство пользователя

Страница: 47 / 65

DC Inverter U-match Series Duct Type Unit
42
3) Use nippers to bend the solid wire into a ring that fits the
terminal screw.
4) Form a proper ring and then put it on the terminal board.
Use a screwdriver to tighten up the terminal screw.
(2) For strand wires (as shown below):
1) Use wire cutters to cut off the wire end and then peel away
about 10mm of the insulation layer.
2) Use a screwdriver to unscrew the terminal screw on the
terminal board.
3) Use a round terminal fastener or clamp to fix the round
terminal firmly on the peeled wire end.
4) Locate the round terminal conduit. Use a screwdriver to
replace it and tighten up the terminal screw (as shown
below).
10mm(3/
8inch)
A Solid wire B Strand wire
Solderless
terminal
Insulation layer
25mm(1inch)