13
❏
8. Fit, then glue the top portion of the pushrod brace into
position all the way up against the “lip” around the wing
saddle—it isn’t critical where the brace is located forward
and aft—where it fi ts best is fi ne. Make sure the brace doesn't
interfere with the exit holes of the aileron servo leads.
❏
9. Center the plastic tubes in the brace, then add and
glue the bottom portion of the pushrod brace and the tubes
into place.
❏
10. Connect the servos to your receiver and power up the
radio with the transmitter. With the servos centered, adjust
the servo arms on the pushrods so they are perpendicular
to the servo arms. Fasten the servo arms to the servos with
the screws that came with them.
❏
11. Still with the radio on, hold the rudder and elevator
centered and tighten the pushrods in the screw-lock
connectors with the M2x3 Phillips screws and a drop of
threadlocker on the threads.
We’ll fi nish radio installation after the motor has
been installed.
Install the Motor
❏
1. On the RimFire .10 use a 1.5mm hex driver to loosen
the set screw in the collar and remove the collar. (If ever
using the motor in a reverse confi guration in the future, be
certain to reinstall the collar.)
