GREAT PLANES BLT, Инструкция по эксплуатации

Страница: 8 / 24

❏
1. Cover the stabilizer/elevator portion of the plan with
wax paper or Plan Protector.
❏
2. From the 1/8” x 1/8” x 24” (3.2mm x 3.2mm x 609.6mm)
balsa sticks, cut and glue together the stabilizer trailing
edge , leading edge , ribs and corner gussets .
❏
3. Remove the stab from your building board. Using a
sanding bar with 220-grit sandpaper, very lightly sand the
stabilizer all over. Be sure to sand in the direction of the
longest sticks.
❏ ❏
4. From the 1/8” x 1/8” x 24” (3.2mm x 3.2mm x
609.6mm) balsa sticks, cut and glue together the outer
frame, ribs and corner gussets of one of the elevators.
❏
5. Repeat step 4 to build the second elevator half.
❏
6. In the right elevator half, use a hobby knife to cut the
1/16” (1.6mm) notch for the elevator control horn.
❏
7. Tape the two elevator halves to the trailing edge of the
stabilizer, aligning the ends of the elevators with the ends of
the stabilizer.
❏
8. From the 1/8" x 24" (3.2mm x 609.6mm) hardwood
dowel, cut an elevator joiner to fit between the two
elevator halves.
❏
9. Remove the elevators from the stabilizer and position
the elevator halves and the 1/8" (3.2mm) dowel against a
straightedge. With the leading edge of the elevator halves
and the dowel straight and flat against your building table,
glue the dowel to the elevator halves.
Build the Stabilizer & Elevator
8